Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Input/Output Signal of TCM
INPUT/OUTPUT SIGNAL OF TCM
| Control item | Fluid pressure control | Select control | Shift control | Lock-up control | CAN communication control | Fail-safe function ((3)) | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Input | PNP switch | X | X | X | X | X | X | ||||||||
| Accelerator pedal position signal ((1)) | X | X | X | X | X | X | |||||||||
| Closed throttle position signal ((1)) | X | X | X | X | |||||||||||
| Engine speed signal ((1)) | X | X | X | X | X | ||||||||||
| CVT fluid temperature sensor | X | X | X | X | X | ||||||||||
| Stop lamp switch signal ((1)) | X | X | X | X | X | ||||||||||
| Overdrive control signal ((1)) | X | X | |||||||||||||
| Primary speed sensor | X | X | X | X | |||||||||||
| Secondary speed sensor | X | X | X | X | X | ||||||||||
| Primary pressure sensor ((4)) | X | ||||||||||||||
| Secondary pressure sensor | X | X | |||||||||||||
| Output | Step motor | X | X | ||||||||||||
| TCC solenoid valve | X | X | X | ||||||||||||
| Lock-up select solenoid valve | X | X | X | ||||||||||||
| Line pressure solenoid valve | X | X | X | ||||||||||||
| Secondary pressure solenoid valve | X | X | |||||||||||||
| O/D OFF indicator signal ((2)) | X | X | |||||||||||||
|
|||||||||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
