Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2009 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Method B

WARNING: This page is about a different variant/trim than selected.

Remove No. 4 ignition coil (1).
- <=: Vehicle front
  
  Fig 1: Identifying No. 4 Ignition Coil
  Courtesy of NISSAN MOTOR CO., U.S.A.
Connect No. 4 ignition coil (1) and No. 4 spark plug with suitable high-tension wire (A) as shown, and attach timing light clamp (B) to this wire.
- <=: Vehicle front
  
  Fig 2: Connecting No. 4 Ignition Coil And No. 4 Spark Plug With Suitable High-Tension Wire
  Courtesy of NISSAN MOTOR CO., U.S.A.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.