Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Service Data And Specifications (SDS): Generator
GENERATOR SERVICE DATA AND SPECIFICATIONS
| Type | A2TJ0281ZC | TG12C033 |
| MITSUBISHI | VALEO | |
| Nominal rating | 12 V - 110 A | |
| Ground polarity | Negative | |
| Minimum revolution under no-load (when 13.5 V is applied) | Less than 1,000 rpm | Less than 1,200 rpm |
| Hot output current (when 13.5 V is applied) | More than 27 A/1,300 rpm More than 95 A/2,500 rpm More than 116 A/5,000 rpm |
More than 47 A/1,500 rpm More than 74 A/1,800 rpm More than 103 A/2,500 rpm More than 117 A/5,000 rpm |
| Regulated output voltage | 14.1 - 14.7 V | 14.2 - 14.6 V |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.