Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Nissan-Datsun Rogue SL, AWDFACTORY OEM SERVICE PROCEDURE
Physical Values
CAUTION:
- Check combination switch system terminal waveform under the loaded condition with lighting switch, turn signal switch and wiper switch OFF is not to be fluctuated by being overloaded.
- Turn wiper intermittent dial position to 4 except when checking waveform or voltage of wiper intermittent dial position. Wiper intermittent dial position can be confirmed on CONSULT-III. Refer to "COMB SW : CONSULT-III FUNCTION (BCM - COMB SW) ".
- BCM reads the status of the combination switch at 10 ms internal normally. Refer to "SYSTEM DIAGRAM ".
TERMINAL DESCRIPTION
| Terminal No. (Wire color) | Description | Condition | Value (Approx.) | |||
|---|---|---|---|---|---|---|
| + | - | Signal name | Input/Output | |||
| 1 (V) | Ground | Ignition key hole illumination control | Output | Ignition key hole illumination | OFF | Battery voltage |
| ON | 0 V | |||||
| 2 (G) | Ground | Combination switch INPUT 5 | Input | Combination switch (Wiper intermittent dial 4) | All switch OFF | 0 V |
| Turn signal switch RH | ||||||
| Lighting switch HI | ||||||
| Lighting switch 1ST | ||||||
| Lighting switch 2ND | ||||||
| 3 (Y) | Ground | Combination switch INPUT 4 | Input | Combination switch (Wiper intermittent dial 4) | All switch OFF | 0 V |
| Turn signal switch LH | ||||||
| Lighting switch PASS | ||||||
| Lighting switch 2ND | ||||||
| Front fog lamp switch ON | ||||||
| 4 (W) | Ground | Combination switch INPUT 3 | Input | Combination switch (Wiper intermittent dial 4) | All switch OFF | 0 V |
| Front wiper switch LO | ||||||
| Front wiper switch MIST | ||||||
| Front wiper switch INT | ||||||
| 5 (R) | Ground | Combination switch INPUT 2 | Input | Combination switch | All switch OFF (Wiper intermittent dial 4) | 0 V |
| Front washer switch (Wiper intermittent dial 4) | ||||||
| Rear washer ON (Wiper intermittent dial 4) | ||||||
Any of the condition below with all switch OFF
|
||||||
| Rear wiper switch ON (Wiper intermittent dial 4) | ||||||
| 6 (P) | Ground | Combination switch INPUT 1 | Input | Combination switch | All switch OFF (Wiper intermittent dial 4) | 0 V |
| Front wiper switch HI (Wiper intermittent dial 4) | ||||||
| Rear wiper switch INT (Wiper intermittent dial 4) | ||||||
| Wiper intermittent dial 3 (All switch OFF) | ||||||
Any of the condition below with all switch OFF
|
||||||
Any of the condition below with all switch OFF
|
||||||
| 7 (L) | Ground | Door key cylinder switch UNLOCK signal | Input | Door key cylinder switch | NEUTRAL position | |
| UNLOCK position | 0 V | |||||
| 8 (R) | Ground | Door key cylinder switch LOCK signal | Input | Door key cylinder switch | NEUTRAL position | |
| LOCK position | 0 V | |||||
| 9 (R) | Ground | Stop lamp switch | Input | Stop lamp switch | OFF (Brake pedal is not depressed) | 0 V |
| ON (Brake pedal is depressed) | Battery voltage | |||||
| 10 (SB) | Ground | Rear window defogger switch | Input | Rear window defogger switch | Not pressed | Battery voltage |
| Pressed | 0 V | |||||
| 11 (SB) | Ground | Ignition switch ACC | Input | Ignition switch OFF | 0 V | |
| Ignition switch ACC or ON | Battery voltage | |||||
| 12 (P) | Ground | Passenger door switch | Input | Passenger door switch | OFF (When passenger door closed) | |
| ON (When passenger door opened) | 0 V | |||||
| 13 (LG) | Ground | Rear door switch RH | Input | Rear door switch RH | OFF (When rear door RH closed) | |
| ON (When rear door RH opened) | 0 V | |||||
| 15(1) (O) | Ground | Tire pressure warning check switch | Input | Ignition switch OFF | ||
| 18(1) (O) | Ground | Remote keyless entry receiver ground | Input | Ignition switch ON | 0 V | |
| 19(1) (V) | Ground | Remote keyless entry receiver power supply | Input | Without Intelligent Key system | At any condition | 5 V |
| With Intelligent Key system |
|
0 V | ||||
| 3 seconds or later after ignition switch OFF to ON | 5 V | |||||
| 20(1) (GR) | Ground | Remote keyless entry receiver signal | Input | Without Intelligent Key system | At any condition |
Factory Service Tools Use the Manual With the Right HardwarePair factory procedures with proven DIY tools so the instructions are easier to execute. Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you. When to See a MechanicStop DIY work and contact a certified mechanic immediately if any of the following apply:
Rather have a pro handle this?A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises. Comes to youSame-day available12-month warranty Get a Free QuoteNo obligation. See pricing before you book. |
