Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Nissan-Datsun GT-R BaseFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Connectors
CONNECTORS LOCATION
| Component | Location |
|---|---|
| B1 (White, 100 Pin) | Left kick panel. See Figure. |
| B3 (White, 12 Pin) | Left kick panel. See Figure. |
| B10 (White, 6 Pin) | Under driver's seat. See Figure. |
| B59 (Black, 4 Pin) | Center rear of luggage area. See Figure. |
| B61 (White, 12 Pin) | Behind right side of rear seat. See Figure. |
| B151 (Black, 4 Pin) | Center rear of luggage area. See Figure. |
| B201 (White, 100 Pin) | Right kick panel. See Figure. |
| B210 (White, 6 Pin) | Under front passenger's seat. See Figure. |
| B252 (White, 12 Pin) | Center front of luggage compartment. See Figure. |
| E3 (Black, 8 Pin) | Right rear of engine compartment. See Figure. |
| E49 (Black, 8 Pin) | Right rear of engine compartment. See Figure. |
| E104 (White, 12 Pin) | Left end of dash. See Figure. |
| E106 (White, 100 Pin) | Left end of dash. See Figure. |
| E251 (Black, 8 Pin) | Right rear of engine compartment. See Figure. |
| F1 (Black, 8 Pin) | Right rear of engine compartment. See Figure. |
| F48 (Gray, 8 Pin) | Rear of engine. See Figure. |
| F103 (White, 46 Pin) | Right end of dash. See Figure. |
| F120 (Gray, 8 Pin) | Rear of engine. See Figure. |
| M6 (White, 100 Pin) | Left end of dash. See Figure. |
| M7 (White, 100 Pin) | Left end of dash. See Figure. |
| M92 (White, 8 Pin) | Right side of dash. See Figure. |
| M106 (White, 12 Pin) | Right side of dash. See Figure. |
| M116 (White, 46 Pin) | Right end of dash. See Figure. |
| M117 (White, 100 Pin) | Right end of dash. See Figure. |
| M135 (White, 12 Pin) | Right kick panel. See Figure. |
| R1 (White, 12 Pin) | Base of left "A" pillar. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.