2009 Nissan-Datsun Cube BaseFACTORY OEM SERVICE PROCEDURE

IGNITION TIMING : Special Repair Requirement

  1. CHECK IGNITION TIMING
    1. Attach timing light to No. 1 ignition coil (1) wire as shown.
      Fig 1: Identifying No. 1 Ignition Coil
      G05914396Courtesy of NISSAN MOTOR CO., U.S.A.
    2. Check ignition timing.
    Fig 2: Identifying Timing Indicator
    G05914397Courtesy of NISSAN MOTOR CO., U.S.A.

    INSPECTION END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.