2009 Nissan-Datsun Cube BaseFACTORY OEM SERVICE PROCEDURE

Diagnosis Procedure

  1. CHECK DTC

    Check that DTC U1001 is not displayed.

    Is DTC detected?Β 

    NO: GO TO 2.

    YES: Perform trouble diagnosis for DTC U1001. Refer to "DTC LOGIC ".

  2. CHECK COMBINATION METER OPERATION

    Refer to "METER SYSTEM : SYSTEM DESCRIPTION ".

    Is the inspection result normal?Β 

    YES: GO TO 3.

    NO: Check combination meter circuit. Refer to "METER SYSTEM : SYSTEM DIAGRAM ".

  3. CHECK INTERMITTENT INCIDENT

    Refer to "INTERMITTENT INCIDENT ".

    INSPECTION END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.