Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Nissan-Datsun Cube BaseFACTORY OEM SERVICE PROCEDURE
Component Parts Location
POWER DISTRIBUTION SYSTEM COMPONENT PARTS LOCATION TABLE
| 1. | Push-button ignition switch M101 | 2. | Stop lamp switch E115 | 3. | Transmission range switch F21 Refer to COMPONENT PARTS LOCATION |
| 4. | IPDM E/R E10, E11, E12, E13, E15, E17 Refer to COMPONENT PARTS LOCATIONΒ |
5. | BCM M68, M70, M71 Refer to COMPONENT PARTS LOCATION |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
