WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.

With ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to data link connector and turn ignition switch ON.

Fig 1: Connecting CONSULT-II To Data Link Connector
Touch "START (NISSAN BASED VHCL)".

Fig 2: Identifying CONSULT II Display - START (NISSAN BASED VHCL)
Touch "BCM" on "SELECT SYSTEM" screen.
If "BCM" is not indicated, go to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

Fig 3: Identifying CONSULT II Display - SELECT SYSTEM
Touch "BCM" on "SELECT TEST ITEM" screen.

Fig 4: Identifying CONSULT II Display - SELECT TEST ITEM
Touch "CONFIGURATION" on "SELECT DIAG MODE" screen.

Fig 5: Identifying CONSULT II Display - SELECT DIAG MODE
Touch "R51/D40/N51" and "OK" on "VEHICLE SELECT" screen.
For canceling, touch "CANCEL" on "VEHICLE SELECT" screen.

NOTE: Confirm vehicle model on IDENTIFICATION PLATE. Refer to "MODEL VARIATION ".

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Write Configuration Procedure

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?