Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Disassembly and Assembly: Disassembly
WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
- Remove center console. Refer to "REMOVAL AND INSTALLATIONΒ ".
- Remove center console lid.
- Remove latch from center console lid.
- Remove hinge from center console lid.
- Remove rear finisher assembly.
- Remove rear cup holder assembly.
- Remove DVD player (if equipped). Refer to "REMOVAL AND INSTALLATION OF DVD PLAYER " (BOSE AUDIO WITHOUT NAVIGATION) or "REMOVAL AND INSTALLATION OF DVD PLAYER " (BOSE AUDIO WITH NAVIGATION).
- Disconnect center console harness connectors.
- Remove cup holder insert and cup holder assembly.
- Remove center console bin.
- Remove center console bracket.
- Remove wire harness bracket.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
