2008 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

DTC Inspection Priority Chart

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart.

Priority DTC
1
  • U1000: CAN COMM CIRCUIT
2
  • B2190: NATS ANTENNA AMP
  • B2191: DIFFERENCE OF KEY
  • B2192: ID DISCORD BCM-ECM
  • B2193: CHAIN OF BCM-ECM
  • B2013: STRG COMM 1
  • B2552: INTELLIGENT KEY
  • B2590: NATS MALFUNCTION
3
  • C1729: VHCL SPEED SIG ERR
  • C1735: IGNITION SIGNAL
4
  • C1704: LOW PRESSURE FL
  • C1705: LOW PRESSURE FR
  • C1706: LOW PRESSURE RR
  • C1707: LOW PRESSURE RL
  • C1708: [NO DATA] FL
  • C1709: [NO DATA] FR
  • C1710: [NO DATA] RR
  • C1711: [NO DATA] RL
  • C1712: [CHECKSUM ERR] FL
  • C1713: [CHECKSUM ERR] FR
  • C1714: [CHECKSUM ERR] RR
  • C1715: [CHECKSUM ERR] RL
  • C1716: [PRESSDATA ERR] FL
  • C1717: [PRESSDATA ERR] FR
  • C1718: [PRESSDATA ERR] RR
  • C1719: [PRESSDATA ERR] RL
  • C1720: [CODE ERR] FL
  • C1721: [CODE ERR] FR
  • C1722: [CODE ERR] RR
  • C1723: [CODE ERR] RL
  • C1724: [BATT VOLT LOW] FL
  • C1725: [BATT VOLT LOW] FR
  • C1726: [BATT VOLT LOW] RR
  • C1727: [BATT VOLT LOW] RL
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.