Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Procedure
- CHECK CAN COMMUNICATION LINE
Perform the self-diagnosis. Refer to "SELF-DIAGNOSTIC RESULT MODE ".
Is any malfunction in the CAN communication indicated in the results?
YES: Check CAN communication line. Refer to "DTC U1000 CAN COMMUNICATION LINE ".
NO: GO TO 2.
- CHECK OVERDRIVE CONTOROL SWITCH CIRCUIT
With CONSULT-II
- Turn ignition switch "ON".
- Select "ECU INPUT SIGNALS" in "DATA MONITOR" mode for "A/T" with CONSULT-II.
- Read out "OD CONT SW".
Check the signal of the overdrive control switch is indicated properly.
DISPLAY VALUE CHARTMonitor item Condition Display value OD CONT SW Releasing overdrive control switch OFF Holding overdrive control switch ON
Without CONSULT-II
- Turn ignition switch "ON". (Do not start engine)
- Check voltage between A/T control device connector terminal and ground.CONNECTOR TERMINAL DATA CHART
Item Connector No. Terminal No. Condition Data (Approx.) Overdrive control switch M156 7 - Ground Releasing overdrive control switch Battery voltage Holding overdrive control switch 0V
OK or NG
OK: GO TO 5.
NG: GO TO 3.
- CHECK OVERDRIVE CONTROL SWITCH
- Turn ignition switch "OFF".
- Disconnect A/T control device connector.
- Check continuity between A/T control device connector M156 terminals 7 and 8.CONTINUITY CHART
Condition Continuity Releasing overdrive control switch No Holding overdrive control switch Yes
OK or NG
OK: GO TO 4.
NG: Repair or replace overdrive control switch.
- DETECT MALFUNCTIONING ITEM
Check the following. If any items are damaged, repair or replace damaged parts.
- Harness for short or open between combination meter connector terminal 20 and A/T control device connector terminal 7.
- Harness for short or open between A/T control device connector terminal 8 and ground.
OK or NG
OK: GO TO 5.
NG: Repair or replace damaged parts.
- CHECK COMBINATION METER
Check the combination meter. Refer to "HOW TO PROCEED WITH TROUBLE DIAGNOSIS ".
OK or NG
OK: INSPECTION END
NO: Repair or replace damaged parts.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
