2008 Nissan-Datsun Sentra Base, StandardFACTORY OEM SERVICE PROCEDURE

Ignition Coil With Power Transistor

CAUTION: Do the following procedure in the place where ventilation is good without the combustible.
  1. Turn ignition switch OFF.
  2. Disconnect ignition coil harness connector.
  3. Check resistance between ignition coil terminals as follows.
    TERMINAL RESISTANCE CHART

    Terminal No. (Polarity) Resistance Ξ© [at 25Β°C (77Β°F)]
    1 and 2 Except 0 or ∞
    1 and 3 Except 0
    2 and 3
  4. If NG, replace ignition coil with power transistor.

    If OK, go to next step.

  5. Turn ignition switch OFF.
  6. Reconnect all harness connectors disconnected.
    Fig 1: Checking Resistance Between Ignition Coil Terminals
    G04875504Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Remove fuel pump fuse (1) in IPDM E/R (2) to release fuel pressure.
    NOTE: Do not use CONSULT-III to release fuel pressure, or fuel pressure applies again during the following procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.