Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Nissan-Datsun Rogue 2WD L4-2.5L (QR25DE)FACTORY OEM SERVICE PROCEDURE
BCM (Body Control Module)
TERMINAL LAYOUT
PHYSICAL VALUES
CAUTION:
- Check combination switch system terminal waveform under the loaded condition with lighting switch, turn signal switch and wiper switch OFF is not to be fluctuated by being overloaded.
- Turn wiper intermittent dial position to 4 except when checking waveform or voltage of wiper intermittent dial position. Wiper intermittent dial position can be confirmed on CONSULT-III. Refer to BCS-26, "COMB SW : CONSULT-III Function (BCM - COMB SW)". COMB SW
- BCM reads the status of the combination switch at 10 ms internal normally. Refer to "System Diagram".
PHYSICAL VALUES
CAUTION:
- Check combination switch system terminal waveform under the loaded condition with lighting switch, turn signal switch and wiper switch OFF is not to be fluctuated by being overloaded.
- Turn wiper intermittent dial position to 4 except when checking waveform or voltage of wiper intermittent dial position. Wiper intermittent dial position can be confirmed on CONSULT-III. Refer to BCS-26, "COMB SW : CONSULT-III Function (BCM - COMB SW)". COMB SW
- BCM reads the status of the combination switch at 10 ms internal normally. Refer to "System Diagram".
Terminals And Reference Values (Part 1):
Terminals And Reference Values (Part 2):
Terminals And Reference Values (Part 3):
Terminals And Reference Values (Part 4):
Terminals And Reference Values (Part 5):
Terminals And Reference Values (Part 6):
Terminals And Reference Values (Part 7):
Terminals And Reference Values (Part 8):
Terminals And Reference Values (Part 8):
Terminals And Reference Values (Part 9):
Terminals And Reference Values (Part 10):
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.