Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Adjustment of PNP switch
- Move selector lever to "N" position.
- Remove control cable from manual lever.
- Loosen PNP switch bolts (A). Insert a pin (ø4 mm) into the adjusting holes (B) on both PNP switch and manual lever for adjusting the position.
- Tighten PNP switch bolts (A).
PNP switch bolts : 5.9 N.m (0.60 kg-m, 52 in-lb)
- Connect control cable on manual lever (B). Refer to "ADJUSTMENT OF CVT POSITION ".
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.