Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Pattern B: Notes
- Turn the ignition switch ON after replacing each part.
- Start engine.CAUTION: Do not start the driving.
- Touch CONSULT-III screen in the order of "DATA MONITOR", and "MAIN SIGNALS".
- Warm up the transaxle assembly until "ATF TEMP" indicates 48 (approximately 20°C) or more. Turn the ignition switch OFF.
- Turn the ignition switch ON.CAUTION: Do not start engine.
- Select "SELF-DIAG RESULTS".
- Shift the selector lever to "R" position.
- Depress slightly the accelerator pedal (Pedal angle: 2/8) while depressing the brake pedal.
- Perform "ERASE".
- Shift the selector lever to "R" position after replacing TCM. Turn the ignition switch OFF.
- Wait approximately 10 minutes after turning the ignition switch OFF.
- Turn the ignition switch ON while shifting the selector lever to "R" position.CAUTION: Do not start engine.
- Select "Special function".
- Check that the value on "CALIBRATION DATA" is same as the data after erasing
"CALIBRATION DATA ".
- Restart the procedure from step 3 if the values are not same.
- Shift the selector lever to "P" position.
- Check that the shift position indicator in the combination meter turns ON (It indicates approximately 1 or 2 seconds after shifting the selector lever to "P" position.)
- Check the following items if the shift position indicator does not turn ON. Repair or replace the shift position indicator if necessary.
- The harness between TCM and ROM ASSY in the transaxle assembly is open or short.
- Cable disconnected, loosen, or bent from the connector housing.
- Power supply and ground of TCM. Refer to "DTC P1701 TRANSMISSION CONTROL MODULE (POWER SUPPLY) ".
- Check the following items if the shift position indicator does not turn ON. Repair or replace the shift position indicator if necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.