Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Procedure
- CHECK DTC
- Turn ignition switch ON.
- Select "SELF-DIAG RESULTS" mode for "TRANSMISSION" with CONSULT-III.
- Erase self-diagnostic results. Refer to "HOW TO ERASE DTC (WITH CONSULT-III) ".
- Turn ignition switch OFF, and wait for 5 seconds or more.
- Start engine.
- Confirm self-diagnostic results again. Refer to "SELF-DIAGNOSTIC RESULT MODE ".
Is the "P1701 TCM-POWER SUPPLY" displayed?
YES: GO TO 2.
NO: INSPECTION END
- CHECK TCM POWER SOURCE, STEP 1
- Turn ignition switch OFF.
- Check voltage between TCM connector terminal and ground.VOLTAGE SPECIFICATION CHART
Name Connector Terminal Condition Voltage (Approx.) Power supply (memory back-up) F23 45 - Ground Always Battery voltage 47 - Ground
OK or NG
OK: GO TO 3.
NG: GO TO 4.
- CHECK TCM POWER SOURCE, STEP 2
- Turn ignition switch ON.
- Check voltage between TCM connector terminals and ground.VOLTAGE SPECIFICATION CHART
Name Connector Terminal Condition Voltage (Approx.) Power supply F23 46 - Ground Battery voltage 0 V Power supply 48 - Ground Battery voltage 0 V Power supply (memory back-up) 45 - Ground Always Battery voltage 47 - Ground
OK or NG
OK: GO TO 5.
NG: GO TO 4.
- DETECT MALFUNCTIONING ITEM
Check the following.
- Harness for short or open between battery and TCM connector terminal 45, 47
- Harness for short or open between ignition switch and TCM connector terminal 46, 48
- 10 A fuse (No.49, located in the IPDM E/R)
- 20 A fuse (No.53, located in the IPDM E/R)
- Ignition switch. Refer to "POWER SUPPLY ROUTING CIRCUIT ".
OK or NG
OK: GO TO 5.
NG: Repair or replace damaged parts.
- CHECK TCM GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect TCM connector.
- Check continuity between TCM connector terminals and ground.CONTINUITY REFERENCE CHART
Name Connector Terminal Continuity Ground F23 5 - Ground Yes 42 - Ground
OK or NG
OK: GO TO 6.
NG: Repair open circuit or short to ground or short to power in harness or connectors.
- CHECK DTC
Perform "DTC CONFIRMATION PROCEDURE ".
OK or NG
OK: INSPECTION END
NG: GO TO 7.
- CHECK TCM
- Check TCM input/output signals. Refer to "TCM INPUT/OUTPUT SIGNAL REFERENCE VALUES ".
- If NG, re-check TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK: INSPECTION END
NG: Repair or replace damaged parts.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
