2006 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Front Suspension System: Precautions: Precautions

  • When installing rubber parts, final tightening must be carried out under unladen condition* with tires on ground. Oil will shorten the life of rubber bushings. Be sure to wipe off any spilled oil. 

    *: Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions. 

  • After installing removed suspension parts, check wheel alignment and adjust if necessary. 
  • Use flare nut wrench when removing or installing brake tubes. 
  • Always torque brake lines when installing. 
  • Lock nuts are unreusable parts; always use new ones. 

    When replacing, do not wipe the oil off the new lock nut before tightening. 

Fig 1: View OF Flare Nut Tubing Wrench
G04076676Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.