2006 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Checking Hydraulic System

Before starting, check belt tension, driving pulley and tire pressure.

  1. Set Tool. Open shut-off valve. Then bleed air. Refer to "BLEEDING HYDRAULIC SYSTEM ".
    Fig 1: Checking Hydraulic System
    G04194760Courtesy of NISSAN MOTOR CO., U.S.A.

    Tool numbers: KV48103500 (J-26357 and J-26357-10) 

    :KV48102500 (J-33914) 

  2. Run engine at idle speed or 1, 000 RPM.
    NOTE: Make sure temperature of fluid in tank rises to 60 - 80°C (140 - 176°F).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.