Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2006 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Combination Switch: Replacement

WARNING: This page is about a different car, the 2005 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

For removal and installation of spiral cable, refer to REMOVAL AND INSTALLATION .

Each switch can be replaced without removing switch base.

Fig 1: Removing Switch Base
Courtesy of NISSAN MOTOR CO., U.S.A.
To remove switch base, remove switch base attaching screws.

Fig 2: Removing Switch Base Attaching Screws
Courtesy of NISSAN MOTOR CO., U.S.A.
Before installing the steering wheel, align the steering wheel guide pins with the screws which secure the combination switch as shown in the figure.

Fig 3: Aligning Steering Wheel Guide Pins
Courtesy of NISSAN MOTOR CO., U.S.A.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.