2006 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Time Control Unit Inspection Table (Without Power Door Locks)

TIME CONTROL UNIT INSPECTION REFERENCE (WITHOUT POWER DOOR LOCKS)

Terminal No. Wire color Connections Operated condition Voltage (Approx.)
1 W/B Seat belt buckle switch LH Unfasten --> Fasten (Ignition key is in "ON" position) 0V --> 5V
2 R Front door switch LH OFF (Closed) --> ON (Open) 5V --> 0V
3 G/B Air control (Rear window defogger switch) OFF --> ON 5V --> 0V
4 L/W Ignition key switch (Insert) Key inserted --> Key removed from IGN key cylinder 12V --> 0V
5 R/G Combination switch (Lighting switch) 1ST, 2ND positions: ON --> OFF 12V --> 0V
7 PU Power source (Fuse) - 12V
8 B Ground - -
9 G Ignition switch (ON, START)- Ignition key is in "ON" or "START" position 12V
10 G/R Rear window defogger relay OFF --> ON (Ignition key is in "ON" position) 0V --> 12V
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.