Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Special Service Tools
The actual shapes of the Kent-Moore tools may differ from those of the special service tools illustrated here.
SPECIAL SERVICE TOOLS
| Tool number (Kent-Moore No.) Tool name |
Description | |
|---|---|---|
| KV40104710 (-) Drift |
Install sensor rotor a: 76.3 mm (3.004 in) dia . b: 67.9 mm (2.673 in) dia . |
|
| ST30720000 (-) Drift |
Install sensor rotor a: 77 mm (3.03 in) dia . b: 55.5 mm (2.185 in) dia . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.