Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Nissan-Datsun Altima SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE
Data Monitor Mode
DATA MONITOR MODE SPECIFICATION
| MONITOR ITEM | CONDITION | SPECIFICATION |
|---|---|---|
| FR RH SENSOR FR LH SENSOR RR RH SENSOR RR LH SENSOR |
Drive vehicle. (Each wheel is rotating.) |
Displays computed vehicle speed from wheel sensor signal. Almost the same speed as speedometer. |
| STOP LAMP SW | Turn ignition switch ON and depress brake pedal. |
Depress the pedal: ON Release the pedal: OFF |
| FR RH IN SOL FR RH OUT SOL FR LH IN SOL FR LH OUT SOL RR RH IN SOL RR RH OUT SOL RR LH IN SOL RR LH OUT SOL |
Ignition switch is turned ON or engine is running. | Operating conditions for each solenoid valve are indicated. ABS is not operating: OFF |
| ACTUATOR RLY | Ignition switch is turned ON or engine is running. | Displays ON/OFF condition of ABS actuator relay. When turning ignition switch ON, ABS actuator relay is operated. |
| MOTOR RELAY | ABS is not operating: OFF ABS is operating: ON |
|
| ABS WARN LAMP | Warning lamp is turned on: ON Warning lamp is turned off: OFF |
|
| BATTERY VOLT | Power supply voltage for control unit |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.