2006 Nissan-Datsun Altima SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE

Encoder and Limit Switch Check (Front LH)

  1. CHECK DOOR WINDOW SLIDE MECHANISM 

    Check the following.

    • Obstacles in window, glass molding, etc.
    • Worn or deformed glass molding.
    • Door sash tilted too far inward or outward.
    • Door window regulator.

    OK or NG 

    OK: GO TO 2.

    NG: Remove obstacles or repair door window slide mechanism.

  2. CHECK LIMIT SWITCH OPERATION 
    1. Turn ignition switch ON.
    2. Check voltage between main power window and door lock/unlock switch connector D7 terminal 9 and ground.
      TERMINAL CONDITION CONTINUITY CHART

      Terminals Condition Voltage (Approx.)
      (+) (-)
      Connector Terminal
      D7 9 (G/W) Ground Front power window LH is between fully-open and just before fully-closed position (ON) 0
      Front power window LH is between just before fullyclosed position and fullyclosed position (OFF) 5
      Fig 1: Checking Voltage Between Main Power Window And Door Lock/Unlock Switch Connector D7 Terminal 9 And Ground
      G04170305Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: GO TO 3.

    NG: Check harness between main power window and door lock/unlock switch and front power window motor LH.

    • OK: Replace front power window motor LH.
    • NG: Replace or repair harness.
  3. CHECK ENCODER 

    Measure voltage between main power window and door lock/unlock switch connector D7 terminal 16 (12) and ground with oscilloscope when power window is in automatic closing operation.

    TERMINAL CONDITION CONTINUITY CHART

    Terminals Condition Voltage
    (+) (-)
    D7 16 (G/Y),(12) (G/Y) Ground Front power window motor LH operation.
    G04077331
    Fig 2: Measuring Voltage Between Main Power Window And Door Lock/Unlock Switch Connector D7 Terminal 16 (12) And Ground
    G04170307Courtesy of NISSAN MOTOR CO., U.S.A.

    ( ): with left and right front power window anti-pinch system 

    OK or NG 

    OK: Replace main power window and door lock/unlock switch.

    NG: Replace front power window motor LH.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.