2006 Nissan-Datsun Altima SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE

Major Components And Control System

MAJOR COMPONENTS AND CONTROL SYSTEM

System Input Output
Remote keyless entry system Remote keyless entry receiver (keyfob)
  • All door locking actuators
  • Trunk lid opener actuator
  • Turn signal lamps
Power door lock system
  • Front power door lock/unlock switch (LH, RH)
  • All door switches
  • Key switch
All door locking actuators
Power supply (IGN/RAP) to power window and sunroof Ignition/retained power supply Power supply to power window and sunroof system
Power supply (BAT) to power window and sunroof Battery power supply Power supply to power window and sunroof system
Panic alarm
  • Key switch and key lock solenoid
  • Remote keyless entry receiver (keyfob)
IPDM E/R
Vehicle security system
  • All door switches
  • Remote keyless entry receiver (keyfob)
  • Main power window and door lock/unlock switch
  • Trunk lamp switch and trunk release solenoid
  • IPDM E/R
  • Security indicator lamp
Auto light system
  • Optical sensor
  • Combination switch
IPDM E/R
Battery saver control
  • Ignition switch
  • Combination switch
  • Front door switch LH and RH
IPDM E/R
Headlamp Combination switch IPDM E/R
Tail lamp Combination switch IPDM E/R
Fog lamp Combination switch IPDM E/R
Turn signal lamp Combination switch
  • Turn signal lamp
  • Combination meter
Hazard lamp Hazard switch
  • Turn signal lamp
  • Combination meter
Room lamp timer
  • Key switch and key lock solenoid
  • Remote keyless entry receiver (keyfob)
  • Main power window and door lock/unlock switch
  • Front door switch LH
  • All door switches
Interior room lamp
Key warning chime
  • Key switch and key lock solenoid
  • Front door switch LH
Combination meter (warning buzzer)
Light warning chime
  • Combination switch
  • Key switch and key lock solenoid
  • Front door switch LH
Combination meter (warning buzzer)
Vehicle-speed-sensing intermittent wiper
  • Combination switch
  • Combination meter
IPDM E/R
Rear window defogger Rear window defogger switch IPDM E/R
Air conditioner switch signal Front air control ECM
Blower fan switch signal Front air control ECM
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.