2006 Nissan-Datsun Altima SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE

Items Of Each Part

NOTE: CONSULT-II will only display systems the vehicle possesses.
EACH PART ITEM

System and item CONSULT-II display Diagnostic test mode (Inspection by part)
WORK SUPPORT SELF-DIAG RESULTS DATA MONITOR ECU PART NUMBER ACTIVE TEST CONFIGURATION CAN DIAG SUPPORT MNTR
BCM BCM x x   x   x x
Power door lock system DOOR LOCK x   x   x    
Rear defogger REAR DEFOGGER     x   x    
Warning chime BUZZER     x   x    
Room lamp timer INT LAMP x   x   x    
Remote keyless entry system MULTI REMOTE ENT x   x   x    
Headlamp HEAD LAMP x   x   x    
Wiper WIPER     x   x    
Turn signal lamp Hazard lamp FLASHER     x   x    
Blower fan switch signal Air conditioner switch signal AIR CONDITIONER     x        
Combination switch COMB SW     x        
NVIS (NATS) IMMU     x   x    
Interior lamp battery saver BATTERY SAVER x   x   x    
Trunk TRUNK     x   x    
Vehicle security system THEFT ALM x   x   x    
Retained power control RETAINED PWR x   x   x    
Oil pressure switch SIGNAL BUFFER     x   x    
Panic system PANIC ALARM         x    
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.