2006 Nissan-Datsun Altima BaseFACTORY OEM SERVICE PROCEDURE

Diagnostic Procedure

  1. CHECK OVERALL FUNCTION 

    Check ASCD indicator under the following conditions.

    ASCD INDICATOR CONDITION SPECIFICATION

    ASCD INDICATOR CONDITION SPECIFICATION
    CRUISE LAMP
    • Ignition switch: ON
    MAIN switch is pressed at first time -> second time ON -> OFF
    SET LAMP
    • MAIN switch: ON
    • When vehicle is between 40 km/h (25 MPH) and 144 km/h (89 MPH)
    ASCD is operating ON
    ASCD is not operating OFF

    OK or NG 

    OK: INSPECTION END 

    NG: GO TO 2.

  2. CHECK DTC 

    Check that DTC U1000 or U1001 is not displayed.

    Yes or No 

    Yes: Perform trouble diagnoses for DTC U1000, U1001, refer to , "DTC U1000, U1001 CAN COMMUNICATION LINE ".

    No: GO TO 3.

  3. CHECK COMBINATION METER OPERATION 

    Does combination meter operate normally?

    Yes or No 

    Yes: GO TO 4.

    No: Check combination meter circuit. Refer to , "COMBINATION METERS ".

  4. CHECK INTERMITTENT INCIDENT 

    Refer to , "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".

    : INSPECTION END 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.