2006 Nissan-Datsun Altima BaseFACTORY OEM SERVICE PROCEDURE

CONSULT-II Reference Value in Data Monitor Mode

Specification data are reference value.

MONITOR ITEM CONDITION SPECIFICATION

MONITOR ITEM CONDITION SPECIFICATION
CRUISE LAMP
  • Ignition switch: ON
MAIN switch is pressed at first time -> second time ON -> OFF
SET LAMP
  • MAIN switch: ON
  • When vehicle is between 40 km/h (25 MPH) and 144 km/h (89 MPH)
ASCD is operating ON
ASCD is not operating OFF
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.