2005 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

ECM Terminals and Reference Value: Preparation

  1. ECM is located in the right side of the cowl top (behind the strut tower).
    Fig 1: Locating ECM In Right Side Of Cowl Top (Behind Strut Tower)
    G02450745Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Remove ECM harness protector.
  3. When disconnecting ECM harness connector, loosen it with levers as far as they will go as shown in Fig 2.
    Fig 2: Loosening ECM Harness Connector
    G02450746Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Connect a break-out box (SST) and Y-cable adapter (SST) between the ECM and ECM harness connector.
    • Use extreme care not to touch 2 pins at one time.
    • Data is for comparison and may not be exact.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.