2005 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

With Power Door Locks: Notes

The warning chime is controlled by the smart entrance control unit.

The warning chime is located in the smart entrance control unit.

Power is supplied at all times:

  • Through 10A fuse (No. 37, located in fuse and fusible link box)
  • To smart entrance control unit terminal 10,
  • Through 10A fuse [No. 12, located in the fuse block (J/B)]
  • To key switch terminal 2, and
  • Through 10A fuse (No. 38, located in the fuse and fusible link box)
  • To combination switch (lighting switch) terminal 11.

With the ignition switch in the ON or START position, power is supplied:

  • Through 10A fuse [No. 10, located in the fuse block (J/B)]
  • To smart entrance control unit terminal 33.

Ground is supplied to smart entrance control unit terminal 16 through body grounds M28 and M54.

When a signal, or combination of signals, is received by the smart entrance control unit, the warning chime will sound.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.