Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
System Description: Notes
Power is supplied at all times:
- from 30A fusible link (letter d, located in the fuse and fusible link box)
- to circuit breaker terminal +,
- through circuit breaker terminal -,
- to power window relay terminal 5.
With ignition switch in ON or START position, power is supplied:
- through 10A fuse [No. 10, located in the fuse block (J/B)],
- to power window relay terminal 1.
Ground is supplied:
- to power window relay terminal 2
- through body grounds M28 and M54.
The power window relay is energized and power is supplied:
- through power window relay terminal 3,
- to main power window and door lock/unlock switch terminal 1,
- to front power window switch RH terminal 5,
- to rear power window switch LH and RH terminal 5.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.