Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2005 Nissan-Datsun Sentra Base, StandardFACTORY OEM SERVICE PROCEDURE

Diagnostic Procedure

CHECK OVERALL FUNCTION
Check ASCD indicator under the following conditions.

Fig 1: ASCD (Cruise Control) Indicator Conditions Chart
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG
- OK : INSPECTION END
- NG : GO TO 2.
CHECK DTC
Check that DTC U1000 or U1001 is not displayed.

Yes or No
- Yes : Perform trouble diagnoses for DTC U1000, U1001, refer to "DTC U1000, U1001 CAN COMMUNICATION LINE ".
- No : GO TO 3.
CHECK COMBINATION METER OPERATION
Does combination meter operate normally?

Yes or No
- Yes : GO TO 4.
- No : Check combination meter circuit. Refer to "COMBINATION METER ".
CHECK INTERMITTENT INCIDENT
Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".
- : INSPECTION END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.