Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Operation Procedure
WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
- Touch ABS, DATA MONITOR in order on CONSULT-II screen.
If ABS is not indicated, go to CONSULT-II Data Link Connector (DLC) Circuit.
CAUTION: When START (NISSAN BASED VHCL) is touched immediately after starting engine or turning on ignition switch, ABS might not be displayed in system selection screen. In this case, repeat the operation from step 2. - Return to Monitor Item Selection screen, and touch ECU INPUT SIGNALS, MAIN SIGNALS or SELECTION FROM MENU. Refer to following information.
- When START is touched, data monitor screen is displayed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
