Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Pinion Bearing Preload Torque
WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the pinion sleeve assembly. Refer to PINION SLEEVE ASSEMBLY .
- Rotate the companion flange back and forth 2 to 3 times. Check for unusual noise, rotation malfunction, and other malfunctions.
- Rotate the companion flange at least 20 times to check for smooth operation of the bearing.
- Using a preload gauge, measure the preload torque of the pinion bearing.
Courtesy of NISSAN MOTOR CO., U.S.A.
Tool number: ST3127S000 (J25765-A)
Preload torque
: 0.10 - 0.39 N.m (0.01 - 0.04 kg-m, 1 - 3 in-lb)
CAUTION: Every rotational part shall rotate smoothly with the specified gear oil.- If measured value is out of the specification, disassemble the pinion sleeve assembly to check and adjust each part.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
