Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Section 814 (Can System)
WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
- Precautions
- Can Communication
- Can System (For TCS Models)
- System Description
- Component Parts and Harness Connector Location
- Wiring Diagram - CAN -
- Work Flow
- Circuit Check Between TCM and Combination Meter
- Circuit Check Between Combination Meter and BCM
- Circuit Check Between BCM and ABS Actuator and Electric Unit (Control Unit)
- ECM Circuit Check
- TCM Circuit Check
- Combination Meter Circuit Check
- BCM Circuit Check
- ABS Actuator and Electric Unit (Control Unit) Circuit Check
- IPDM E/R Circuit Check
- CAN Communication Circuit Check
- IPDM E/R Ignition Relay Circuit Check
- Component Inspection
- Can System (For A/T Models)
- System Description
- Component Parts and Harness Connector Location
- Wiring Diagram - CAN -
- Work Flow
- Circuit Check Between TCM and Combination Meter
- Circuit Check Between Combination Meter and BCM
- ECM Circuit Check
- TCM Circuit Check
- Combination Meter Circuit Check
- BCM Circuit Check
- IPDM E/R Circuit Check
- CAN Communication Circuit Check
- IPDM E/R Ignition Relay Circuit Check
- IPDM E/R Check
- Component Inspection
- Can System (For M/T Models)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.