2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Key Fob Id Set Up With Consult-II

WARNING: This page is about a different car, the 2003 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If a key fob is lost, the ID code of the lost key fob must be erased to prevent unauthorized use. When the ID code of a lost key fob is not known, all controller ID codes should be erased. After all ID codes are erased, the ID codes of all remaining and/or new key fobs must be re-registered.
  1. Turn ignition switch "OFF".
  2. Connect "CONSULT-II" to the data link connector.
    Fig 1: Locating Data Link Connector And Hood Opener Handle
    G02161930Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Turn ignition switch ON.
  4. Touch "START".
    Fig 2: Displaying Start Mode
    G02161931Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Touch "BCM".
    Fig 3: Displaying Select System Mode
    G02161932Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Touch "MULTI REMOTE ENT".
    Fig 4: Displaying Select Test Item Mode
    G02161933Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Touch "WORK SUPPORT".
    Fig 5: Displaying Select Diagnostic Mode
    G02161934Courtesy of NISSAN MOTOR CO., U.S.A.
  8. The items are shown on the figure at left can be set up.
    • "REMO CONT ID CONFIR"

      Use this mode to confirm if a key fob ID code is registered or not.

    • "REMO CONT ID REGIST"

      Use this mode to register a key fob ID code.

      NOTE: Register the ID code when key fob or BCM is replaced, or when additional key fob is required.
    • "REMO CONT ID ERASUR"

      Use this mode to erase a key fob ID code.

    Fig 6: Displaying Select Work Item Mode
    G02161935Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.