2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Vehicle Condition Setting Is Not Possible

WARNING: This page is about a different car, the 2003 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.
  1. HARNESS CHECK 
    1. Turn ignition switch OFF.
    2. Disconnect connectors of combination meter, BCM, and AV and NAVI control unit.
    3. Check continuity AV and NAVI control unit and BCM.
      Fig 1: Electrical Testing Specifications (Vehicle Condition Setting Not Possible - 1 Of 2)
      G02024349Courtesy of NISSAN MOTOR CO., U.S.A.
    4. Check continuity between AV and NAVI control unit and ground.
      Fig 2: Electrical Testing Specifications (Vehicle Condition Setting Not Possible - 2 Of 2)
      G02024350Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.