Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Communication System B
- CONNECTOR INSPECTION
Check the terminals (at the control unit and harness) on the malfunctioning LCU for disconnection, bend, and other malfunctions.
OK or NG
OK >> GO TO 2.
NG >> Repair terminals and connectors.
- LCU INSPECTION
Replace the LCU with a known-good one, and perform the communication diagnosis. Refer to "IVMS COMMUNICATION INSPECTION " (with CONSULT-II), "COMMUNICATION DIAGNOSIS " (without CONSULT-II).
OK or NG
OK >> Replace LCU.
NG >> Repair communication harness between the indicated LCU and BCM.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.