2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Wake-Up Control

WARNING: This page is about a different car, the 2004 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Diagraming Wake-Up Control Mode Process
G02340843Courtesy of NISSAN MOTOR CO., U.S.A.

As shown in Fig 1 , when the BCM detects a wake-up signal, it wakes up the whole system and starts communicating again. The sleep mode of all LCUs is now canceled, and the BCM returns to the normal control mode. When any one of the following switches are turned ON, the sleep mode is canceled:

  • All switches combined or connected with BCM
  • All switches combined or connected with LCU

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.