Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Diagnostic Procedure
WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK OVERALL FUNCTION
Check ASCD indicator under the following conditions.
OK or NG
- OK : INSPECTION END
- NG : GO TO 2.
- CHECK DTC
Check that DTC U1000 or U1001 is not displayed.
OK or NG
- OK : GO TO 3.
- NG : Perform trouble diagnosis for DTC U1000, U1001. Refer to EC-134, "DTC U1000, U1001 CAN COMMUNICATION LINE" .
- CHECK DTC WITH COMBINATION METER
Refer to DI-5, "COMBINATION METERS" .
OK or NG
- OK : GO TO 4.
- NG : Go to COMBINATION METERS .
- CHECK INTERMITTENT INCIDENT
Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT .
- : INSPECTION END
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
