2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Adjustable Accelerator Pedal Assembly: Removal

WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Move the accelerator and brake pedals to the frontmost position.
  2. Turn the ignition switch OFF and disconnect the negative battery terminal.
  3. Disconnect the adjustable brake pedal cable from the adjustable brake pedal.
    • Unlock, then pull the adjustable brake pedal cable to disconnect it from the adjustable brake pedal.
  4. Disconnect the adjustable pedal electric motor electrical connector.
  5. Disconnect the adjustable pedal electric motor memory electrical connector, if equipped.
  6. Disconnect the accelerator position sensor electrical connector.
  7. Remove the two upper and one lower accelerator pedal nuts.
  8. Remove the adjustable accelerator pedal assembly.
Fig 1: Identifying Connectors
G00726087Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.