Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Mounting Bolts | |||
| M/T & 5-Speed A/T | 36-46 (49-62) | ||
| 4-Speed A/T | |||
| Long Bolt | 52-58 (70-79) | ||
| Short Bolt | 36-46 (49-62) | ||
| INCH Lbs. (N.m) | |||
| Battery Cable Stud Nut | 65-88 (7.3-9.8) | ||
| Case Through Bolts | 39-63 (4.4-7.1) | ||
| Solenoid Bolts | 36-67 (4.1-7.6) | ||
| Starter Insulator Bolt (5-Speed A/T) | 64-96 (7.2-10.8) | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.