2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Generator Specifications

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
GENERATOR SPECIFICATIONS

Application Specification
Generator Model TG12C014, VALEO
Nominal Rating 12 Volts, 110 Amps
Ground Polarity Negative
Minimum RPM Under No Load (With 13.5 Volts Applied) 1100 RPM
Hot Output Current (With 13.5 Volts Applied)
At 1500 RPM 27 Amps
At 2500 RPM 90 Amps
At 5000 RPM 112 Amps
Regulated Output Voltage 14.2-14.6 Volts @ 25Β°C
Minimum Brush Length .173 in. (4.40 mm)
Brush Spring Pressure 6.49-11.28 ozs. (1.8-3.1 N)
Slip Ring Minimum Outer Diameter .47 in. (12.00 mm)
Rotor (Field Coil) Resistance 2.3 Ohms
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.