Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Front Wheel Alignment: Toe-In
WARNING: This page is about a different car, the 2004 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Always perform the following procedure on a flat surface.
- Make sure that no person is in front of the vehicle before pushing it.
- Bounce the front of vehicle up and down to stabilize the vehicle height (posture).
- Push the vehicle straight ahead about 5 m (16 ft).
- Put a mark on base line of the tread (rear side) of both front tires at the hub center height as shown. These marks are measuring points.
- Measure the distance "A" on the rear side of the front tires as shown.
- Push the vehicle slowly ahead to rotate the wheels 180° degrees (1/2 a turn).CAUTION: If the wheels have rotated more than 180° degrees (1/2 turn), start this procedure again from the beginning. Never push the vehicle backward.
- Measure the distance "B" on the front side of the front tires at the same marks as shown.
Total toe-in : Refer to "SPECIFICATIONS ".
- Adjust the toe-in by varying the length of the steering outer tie rods.
- Loosen the outer tie-rod lock nuts.
- Adjust the toe-in by screwing the outer tie-rods in or out.
- Tighten the outer tie-rod lock nuts to specified torque.
Outer tie-rod grooved nut : 29 - 39 N.m (3 - 4 kg-m, 22 - 29 ft-lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
