2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Rear Wheel Alignment: Toe-In

WARNING: This page is about a different car, the 2003 Nissan Altima and 2002 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.

Measure toe-in using following procedure. If out of specification, inspect and replace any damaged or worn rear suspension parts.

WARNING:
  • Always perform the following procedure on a flat surface.
  • Make sure that no person is in front of the vehicle before pushing it.
  1. Bounce rear of vehicle up and down to stabilize the posture.
  2. Push the vehicle straight ahead about 5 m (16 ft).
  3. Put a mark on base line of the tread (rear side) of both tires at the same height of hub center. This mark is a measuring point.
    Fig 1: Identifying Measuring Point
    G00795326Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Measure distance "A" (rear side).
  5. Push the vehicle slowly ahead to rotate the wheels 180 degrees (1/2 turn).

    If the wheels have rotated more than 180 degrees (1/2 turn), try the above procedure again from the beginning. Never push vehicle backward.

  6. Measure distance "B" (front side).
    1. Total toe-in : Refer to Β SPECIFICATIONSΒ Β  .
    Fig 2: Measuring Toe-In
    G00795327Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Adjust toe-in by turning adjusting bolt.
    NOTE: Toe changes about 1.5 mm (0.059 in) [One side] with each graduation of the adjusting bolt.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.