2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Front Wheel Alignment: Toe-In

WARNING: This page is about a different car, the 2003 Nissan Altima and 2002 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.

Measure toe-in using the following procedure.

WARNING:
  • Always perform the following procedure on a flat surface.
  • Make sure that no person is in front of the vehicle before pushing it.
  1. Bounce front of vehicle up and down to stabilize the posture.
  2. Push the vehicle straight ahead about 5 m (16 ft).
  3. Put a mark on base line of tread (rear side) of both tires at the same height as hub center. These are measuring points.
    Fig 1: Identifying Measuring point
    G00795231Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Measure distance "A" (rear side).
  5. Push the vehicle slowly ahead to rotate the wheels 180 degrees (1/2 turn).

    If the wheels have rotated more than 180 degrees (1/2 turn), try the above procedure again from the beginning. Never push vehicle backward.

  6. Measure distance "B" (front side).
    1. Total toe-in : Refer to SPECIFICATIONS   .
    Fig 2: Measuring Toe-In
    G00795232Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Adjust toe-in by varying the length of steering tie-rods.
    1. Loosen lock nuts.
    2. Adjust toe-in by screwing tie-rods in and out.
      1. Standard length "L" : Refer to SERVICE DATA AND SPECIFICATIONS (SDS)  .
    3. Tighten lock nuts to specified torque.
      1. Lock nut tightening torque: Refer to REMOVAL AND INSTALLATION  .
      Fig 3: Adjusting Toe-In
      G00795233Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.