Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Ignition Coil With Power Transistor
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do the following procedure in the place where ventilation is good without the combustible.
- Turn ignition switch OFF.
- Disconnect ignition coil harness connector.
- Check resistance between ignition coil terminals as follows.IGNITION COIL TERMINALS SPECIFICATION
Terminal No. (Polarity) Resistance Ξ© 1 [at 25Β°C (77Β°F)] 1 and 2 Except 0 or β 1 and 3 Except 0 2 and 3 - If NG, replace ignition coil with power transistor.
If OK, go to next step.
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Remove fuel pump fuse located in IPDM E/R to release fuel pressure.NOTE: Do not use CONSULT-III to release fuel pressure, or fuel pressure applies again during the following procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.