2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

With CONSULT-II

WARNING: This page is about a different car, the 2005 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Select "ETHANOL M/R ADJ" in "WORK SUPPORT" mode with CONSULT-II, then touch "START".
    Fig 1: Identifying CONSULT-II ETHANOL M/R ADJ Screen
    G03601399Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Select "E35" and then touch "UPDATE".
    Fig 2: Selecting "E35" And Touching "UPDATE" Screen
    G03601400Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Crank engine and make sure that engine starts.

    If NG, go to next step.

  5. Select "E70" and then touch "UPDATE".
    Fig 3: Selecting "E70" And Touching "UPDATE"
    G03601401Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Crank engine and make sure that engine starts.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.