Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Bleeding Brake System
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Carefully monitor brake fluid level at master cylinder during bleeding operation.
- Fill reservoir with new brake fluid "RECOMMENDED FLUIDS AND LUBRICANTS ". Make sure it is full at all times while bleeding air out of system.
- Place a container under master cylinder to avoid spillage of brake fluid.
- Do not loosen the connecting portion of the actuator during air bleeding.
- Disconnect battery negative terminal.
- Connect a transparent vinyl tube and container to air bleeder valve.
- Fully depress brake pedal several times.
- With brake pedal depressed, open air bleeder valve to release air.
- Close air bleeder valve.
- Release brake pedal slowly.
- Tighten air bleeder valve to specification.
Air bleeder valve: 8 N.m (0.8 kg-m, 69 in-lb)Â
- Repeat steps  2 through  7 until no more air bubbles come out of air bleeder valve.
- Bleed the brake hydraulic system air bleeder valves in the following order:
Right rear brake → Left front brake → Left rear brake → Right front brakeÂ
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
