Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Section 2074 (Maintenance)
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Precautions
- Preparation
- General Maintenance
- Periodic Maintenance
- Recommended Fluids And Lubricants
- Engine Maintenance
- Chassis And Body Maintenance
- Changing In-cabin Microfilter
- Checking Exhaust System
- Checking CVT Fluid
- Changing CVT Fluid
- Balancing Wheels (Bonding Weight Type)
- Tire Rotation
- Checking Brake Fluid Level and Leaks
- Checking Brake Lines and Cables
- Checking Disc Brake
- Checking Steering Gear and Linkage
- Checking Power Steering Fluid and Lines
- Axle and Suspension Parts
- Drive Shaft
- Lubricating Locks, Hinges and Hood Latch
- Checking Seat Belts, Buckles, Retractors, Anchors and Adjusters
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.